I had a very productive day today i completed the installation of new carpet in my 1967 mgb gt.
Mgb carpet installation instructions.
Spray adhesive on the ramp and on the back of the carpet.
Install the carpet that covers the ramp in the rear area of the car.
Lay it down so the top of the carpet piece is even with the top of the ramp.
Apply glue to the underside of the carpet and the lower bulkhead.
Tools needed for installation 4 general instructions and tips 4 getting started 4 6 carpet removal and installation 6 8 door panel removal and installation 8 9 seat cover removal and mg 28.
Lay it down so the top of the carpet piece is even with the top of the ramp.
Now on to the next project replacing all of the fuel line in my 1978 mgb touring.
Interior kit installation instructions.
Installing mgb budget carpet set 1 remove seats.
Measure the distance from the rear ramp to the gear stick.
For the underseat carpet use an awl to find the seat holes and cut a circle of carpet and padding at each location.
Fitting rear lower bulkhead carpet place into position to make sure that the ends fit neatly over the sill carpet.
I bought the moss standard carpet kit and the instructions leave a bit to the imagination when it comes to which pieces fit where precisely.
Attach the front carpet then fit and trim the tunnel carpet around the shifter opening.
Install the carpet that covers the ramp in the rear area of the car.
Install the tunnel carpet.
Also remove carpet along door sill and on rear wheel arches glued down and from the floor clipped in front glued and held by seat runners in rear and the transmission tunnel and inside footwells.
Cut a small hole for the lever then enlarge the hole after the carpet is fitted.
Carpet removal and installation part 1 remove the toeboard carpet and backing which are held in place by small phillips screws.
This is moss part 224 315.
3 remove center console and armrest if fitted.
2 remove front kick panels rear bulkhead panel and both rear quarter panels.